RKP - Checkerboard Carbon Fiber Front Lip Spoiler - BMW F10 M5
The RKP front lip for the F10 M5 attempts to go above and beyond the standard fare of aerodynamic parts available for BMW M cars. Where most front lips simply extend and lower the front of the car, the RKP lip adapts the original BMW design, and attempts to expand on what's already there.
Instead of simply jutting straight from the front bumper, the RKP F10 M5 front lip is designed with BMW's own design language in mind, integrating the crisp lines of the front bumper into the lip's surface. The body lines molded into the front bumper of the M5 are retained in the outside surfaces of the front lip, and move and flow into the front lip's outer surface to create a piece that is visually cohesive.
This F10 M5 front lip fits perfectly against the M5's front bumper, leaving essentially no gap after the lip is installed. Installation is accomplished using 3M adhesive tape, and fasteners that are already present in the front bumper. No drilling is required to install the front lip, and no new hardware is used. The RKP front lip does not lower the M5's ride height as it does not extend past the lowest point of the front bumper.
Each RKP front lip for the F10 M5 is built from 100% carbon fiber, and is available in plain or twill weave. Extreme care is taken to ensure that each lip has an excellent weave pattern and alignment, with no misweave or flaws.
- Checkerboard Carbon Fiber Weave Construction
- Gloss Clear or Matte Clear finish
- Complete the look with an optional Checkerboard Carbon Fiber Rear Diffuser
2012+ BMW F10 M5
|BMW Fitments||F10 M5|